Service areas / Los Angeles County

Concrete, pavers and masonry in Santa Fe Springs

Santa Fe Springs is about 4 miles southwest of our Whittier base. Driveways, patios, block walls and backyards, with Jose quoting every job himself, free.

Building in Santa Fe Springs

Much of the housing here is post-war: single-story homes on flat lots, many with the driveway and patio they were built with. After sixty or seventy years, tree roots, settling and old repairs show up as heaved panels and wide cracks.

  • Flat lots, so drainage comes down to the slope we build into the slab
  • Old driveways often need tear-out and a new base, not a patch
  • Parkway trees push up driveways and walks near the street

What we build here

Prices

Rough prices in Santa Fe Springs

2026 installed ranges for the jobs we build most in the Gateway Cities. Same numbers as our calculator.

JobRough installed price
Concrete drivewayTwo car, 20 x 24 ft$5,300 to $7,200
Concrete patioTypical, 12 x 20 ft$2,150 to $3,350
Paver patioTypical, 12 x 20 ft$4,800 to $7,700
Block wall60 ft, 6 ft tall$6,000 to $9,900
Concrete walkway4 x 30 ft$1,500 to $2,100
Fire pitOne built-in fire pit$2,800 to $7,400

Planning numbers. Jose's free on-site quote is the real price. All cost guides

Permits in Santa Fe Springs

Permits for work in Santa Fe Springs go through the City of Santa Fe Springs. Under the California Building Code, flat work like a patio or walkway on grade usually needs no building permit, but a new driveway approach or curb cut needs a permit for work in the street, and walls over the code limits need one too. Jose checks what your job needs when he quotes it, and pulls any permit as part of the job.

Questions from Santa Fe Springs homeowners

Do you work in Santa Fe Springs?

Yes. Santa Fe Springs is about 4 miles southwest of our Whittier base. We build concrete, pavers, block walls and backyard hardscape in Santa Fe Springs and across Los Angeles County.

How much does a concrete driveway cost in Santa Fe Springs?

A two-car concrete driveway (about 480 sq ft) runs about $5,300 to $7,200 installed with a broom finish, in 2026 Southern California prices. Tear-out of an old driveway adds about $3 to $7 per sq ft.

Do I need a permit in Santa Fe Springs?

Permits for work in Santa Fe Springs go through the City of Santa Fe Springs. Under the California Building Code, flat work like a patio or walkway on grade usually needs no building permit, but a new driveway approach or curb cut needs a permit for work in the street, and walls over the code limits need one too. Jose checks what your job needs when he quotes it, and pulls any permit as part of the job.

How do I get a quote in Santa Fe Springs?

Fill out the short quote form with your zip code. Jose looks at every request himself, comes out to see the job and gives you a written price, free.

Get my free quote